Assigning Input Channels - Tascam DP-004 Owner's Manual

Tascam portable 4-track digital pocketstudio owner's manual
Hide thumbs Also See for DP-004:
Table of Contents

Advertisement

NOTE
If an OL indicator in the input section is lighting even
though the input meter is showing a suitable level, the
input signal is too strong and the sound is distorted.
Lower the volume output on the input source.
Track meters (1–4)
These meters show either the playback signal level
or the input signal level for each track. The signal
levels shown by the track meters depend on the
operating conditions as shown below.
indicator not lit during playback: track play-
REC
back signal
indicator blinking (record standby) during
REC
playback: track playback signal
indicator blinking (record standby) when the
REC
transport is stopped: track input signal
indicator lit (during recording): track input
REC
signal
NOTE
When the playback signal is shown, the level of the
recorded signal of the track is shown, so the level shown
by the meters cannot be changed. When the input signal
is being shown, the input levels, and thus the meters,
6–Basic Recording
can be changed using the LEVEL knobs for INPUT A and
INPUT B.
Stereo meters (L, R)
These show the stereo bus output level of this unit.
Adjust the output level with the
NOTE
When an input source is a built-in mic, if the REC indica-
tor is not lit on the track that is set to record the built-in
mic, no signal is sent to the stereo bus, so the meters do
not move.

Assigning input channels

In this unit, assigning an input channels allows you
to assign the signal input from INPUT A or INPUT
B as the source for recording on a track.
This unit can simultaneously record a maximum of
two tracks. You can also record one input channel to
two tracks simultaneously (in this case, you cannot
use the other input channel). You cannot assign two
input channels to the same track.
knob.
MASTER LEVEL
57
TASCAM DP-004

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents