Tally Genicom 6600 User Manual [Page 171]: Reverse Print Command (create)
Tally genicom printer user manual.
Reverse Print Command (Create)
This command allows you to define an area on a form where reverse printing
(white ouput on black background) will be output.
Reverse printing cannot be used with OCR Characters or Overlay Data.
Field
REVERSE
This is the command specifier.
Using the following parameters a
field of reverse printing will be
defined for a location on a form.
D;
Optional parameter for changing
Dark Printing
horizontal dot density from 60 DPI
to 120 DPI.
The SR, SC, ER, and EC parameters use the same methods for defining the REVERSE Print
area. Whether in columns or dots depends on the SCALE Command. You may also use the
XX.YY format for plotting duplication print locations explained earlier in the Standards Section.
SR;
Plots the starting ROW of the field.
SC;
Plots the starting COLUMN of the
field.
ER;
Plots the ending ROW of the field.
The ending row must be greater
than the starting row.
EC
Plots the ending COLUMN of the
field. The ending column must be
greater than the starting column.
STOP
Command Terminator.
Table 15. Reverse Command
Function
Option/Modifier Selections
Enter REVERSE
Enter D; or DARK; to select this option.
Enter a value ranging from 1 to one less
than the maximum form length and the
delimiter.
Enter a value ranging from 1 to one less
than the maximum form width and the
delimiter.
Enter a range ranging from 2 to one less
than the maximum form length and the
delimiter.
Enter a value ranging from 2 to the
maximum form width.
Enter STOP and the printer waits for a new
command. Leave it out and the printer will
wait for another REVERSE Command.
171
Comments to this Manuals
Latest comments: