Product Details; Time Standards; Global Positioning System (Gps); Version - Symmetricom SyncServer S100 User Manual

Symmetricom network device user guide s100
Hide thumbs Also See for SyncServer S100:
Table of Contents

Advertisement

Product Details

Details about the physical description and operating environment of the S100 are found in
Appendix A,
Details about S100 operations are in
"Chapter 3" on page

Time Standards

The international time standard is called Coordinated Universal Time or, more commonly,
UTC. This standard was agreed upon in 1972 by worldwide representatives within the
International Telecommunications Union; today, the Internet Engineering Task Force (IETF)
sets standards based on the 1972 work. Today UTC is coordinated by the world's
International Bureau of Weights and Measures, or BIPM. (The designations "UTC" and
"BIPM" were chosen as a compromise among all the countries' abbreviations for the terms.)
The global availability and precision of UTC time makes it the ideal source of time for Time.
The S100 uses UTC as its time standard.

Global Positioning System (GPS)

The U.S. Department of Defense Global Positioning System (GPS) is a constellation of
approximately 29 satellites that orbit Earth twice a day. Their orbits are inclined 56 degrees to
the equator. The GPS satellites signals are used by a GPS receiver to precisely determine its
own position and time.
The orbits of these satellites and the offset (relative to international standard time, UTC) of
their on-board Cesium atomic clocks is precisely tracked by the U.S. Air Force control
network. Position and time correction information is uplinked from the ground control stations
and maintained in the satellites in what are termed ephemeris tables, or tables of data that
describe the satellite's position when compared to specified coordinates. Each satellite
transmission reports the satellite's current position, GPS time, and the offset of the satellite's
clock relative to UTC, international standard time.
The "S100 GPS" model uses GPS to obtain time. (The "S100 ACTS" model obtains time by
dialing NIST's Automated Computer Time Service (ACTS).)
S100 User Guide – Rev. D – June 2005
"S100 Specifications" on page 119
13, and
"Operations & Time-Protocols" on page
of this User Guide.
"The Web-Based Interface" on page
53, as well as
87.
2
3
5
3
1

Advertisement

Table of Contents
loading

Table of Contents