Symbol P370 Product Reference Manual page 23

Cordless rf scanners
Hide thumbs Also See for P370:
Table of Contents

Advertisement

7. Rotate the antenna to the vertical position.
Using A Synapse Cable
1. Make sure all host devices are powered down.
Before power is provided to the cradle (step 6), the following steps must be
completed. The Synapse cable must be connected to the cradle (step 2) AND the
flying power lead plugged in (step 4). If the cables are not connected in this
sequence, the Synapse Interface Adapter will not operate properly.
2. Connect the Synapse cable to the cradle (see
3. Connect the other end of the Synapse cable to the Synapse Interface adapter.
4. The Synapse cable has a flying power lead. Connect this lead to the receptacle in
the Synapse Interface adapter, as shown in
details.
To Host
5. Connect the Synapse Interface adapter to the host.
6. Connect the power supply to the cradle (see
IMPORTANT
Flying Power
Lead
Figure 2-3. Synapse and Adapter Cable
Figure 2-1 on page
Figure
2-3. See the Synapse guide for
Synapse Interface
Adapter (Module)
Synapse
Cable
To Cradle
Figure
2-2).
Set Up
2-2).
2-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

P470P 370 rf

Table of Contents