I Setup; Automatic Channel Set Up - Sylvania SSD803 Owner's Manual

AUTOMATIC CHANNEL SET UP

You can automatically program the tuner to scan only
the channels you receive in your area.
¡ Channel memory programming is NOT needed
when you connect the VCR to a cable box or a satel-
lite box as in "CONNECTING TO A TV WITHOUT
A/V TERMINALS" on page 13. In this case, select
channel 3 on your TV. Then, the channel you want to
record or view may be selected at the cable box or
satellite box.
¡ If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV.
¡ Follow the steps below once. Repeat only if there
is a power failure or if the VCR is unplugged for
more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
¡
You must follow the steps below before attempting
to play or record a video tape. If you want to play
or record a video tape BEFORE programming the
tuner, you can cancel it by pressing
CLEAR/C.RESET.
1
You need to connect the antenna or cable to
the VCR first. Then, connect the DVD /VCR
power plug to a standard AC outlet.
2
Turn on the TV and set the TV to channel 3.
¡ If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV. (See "RF OUTPUT
CHANNEL" on page 13 for the detail.)
3
Turn on the VCR by pressing POWER. the
POWER light will come on.
4
Select the On Screen Language ("ENG-
LISH", "FRANCAIS" or
"ESPAÑOL") by pressing K
or L. Then, press B.
5
Begin channel preset by pressing B once.
The tuner scans and memorizes all active
channels in your area.
¡ The VCR distinguishes between
standard TV channels and cable
channels.
SETUP
6
After scanning, the tuner stops on the low-
VCR
est memorized channel. The TV screen
returns to TV mode.
¡
If "AUTO SET UP" appears on the TV screen again,
check the cable connections. Press
the VCR will begin preset again.
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using CHAN-
NEL (o/p) or by directly pressing Number on the
remote control.
Note for using the Number:
¡
When selecting cable channels which are higher
than 99, enter channel numbers as a three-digit num-
ber.(For example: 117, press 1,1,7)
¡
You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
TO PRESET THE CHANNELS AGAIN
1
Press MENU until the main menu appears.
(If you have already set the clock, you only
have to press it once. If not, you have to
press it twice).
2
Select "CHANNEL SET UP" by pressing K
or L. Then, press B.
3
Select "AUTO SET UP" by pressing K or L.
Then, press B.
¡
After scanning, the tuner stops on the lowest memo-
rized channel.
CH 01
AUTO SET UP
– 16 –
once again and
B
EN
1L25