Robin America DY30 Service Manual page 57

3 .
Mounting to Engine
a)
Supply grease into the grease filler hole (the section shown with inclined lines in the figure) of the input shaft.
b) Set the packing in the coupling, and then clamp it to the engine's flywheel with four 10 mm x
30 9T bolts.
Tightening torque: 550-700 kg-cm'
c) Apply grease to the coupling and spline gear teeth of the input shaft.
d) Set the 1/2 reducer in the engine under the condition that the spline teeth are engaged, and clamp it with four
8 mm
x
65 7T bolts. Tightening torque: 200
-
230 kg-cm."
r
FLYWHEEL
T
S H A F T
\
GREASE F I L L E R
HOLE
COUPLING
Fig. 12-
70
-
54
-