Summary of Contents for ESI Q CRANK Series
- Page 1 Q CRANK Model Q Crank-24S-___ Model Q Crank-24L-___ Model Q Crank-30S-___ CRANK TABLE BASE Model Q Crank-30L-___ _ _ _ = SLV, BLK or WHT Q CRANK Rev A 1/17 ASSEMBLY AND OPERATION...
-
Page 2: Parts And Tools
Q CRANK TABLE BASE PARTS AND TOOLS PLEASE REVIEW these instructions before beginning the assembly procedures. Check that all the parts shown below were provided with your order. Contact your supplier if any materials are missing. Do not discard the packaging until satisfied that the product operates to your satisfaction. - Page 3 ASSEMBLY Q CRANK TABLE BASE STEP 1 With the table top facing down on a soft, clean surface, arrange the cross channels and top supports as shown. • Positioning does not need to be exact Cross Channel at this time. •...
- Page 4 Q CRANK TABLE BASE ASSEMBLY STEP 5 Attach a foot plate and foot to each of the side legs with the M6x35 screws. M6x35 Rear • First, place the foot plate onto the leg with the smooth side up. • Position the foot over the foot plate, as shown. The short side of each foot should face the rear.
- Page 5 ASSEMBLY Q CRANK TABLE BASE STEP 9 Use a 2mm Allen key to loosen the set screws on each end of the gear connector’s outer cylinder. • This will allow you to adjust the length of the gear connector shaft so that you can insert the shaft into Loosen Set Screws gear drive of the two legs.
- Page 6 • Turning the handle clockwise raises the table. Turning the handle counter-clockwise lowers it. • If there are problems with operation, check that all shaft ends are securely inserted. If problems continue, call ESI Customer Service.
-
Page 7: Operation
OPERATION Q CRANK TABLE BASE OPERATION When not in use, the crank handle is typically Crank hidden under the work surface, held in place by Handle Bracket the crank handle bracket. To use the crank to operate the table, pull the handle out slightly and rotate it 90°... - Page 8 800.833.3746 esiergo.com © 2017 ESI Ergonomic Solutions. All rights reserved. Q CRANK Rev A 1/17...