Advertisement
Quick Links
INSTALLATION, OPERATION, AND SERVICE MANUAL FOR
KB SERIES BOTTLED WATER BREWERS
KB-APF/LDF
Model
Warmers
KB-1F
1
KB-2F
2
KB3-F
3
KB-TCF
0
KBAPF/LDF*
0
*We recommend up to 3 gallon bottles only due to stability, unless anchored to wall.
WARNING – Read and follow installation instructions before plugging or wiring in machine to electrical circuit. Warranty
FILL BREWER TANK WITH WATER BEFORE CONNECTING TO POWER SUPPLY!
1.) Place bottle on top of brewer with neck of bottle extending into receiving hole.
2.) Hold faucet open until water flows from it. Allow one minute for automatic leveling of water in tank. Plug or wire brewer to
appropriate voltage circuit as indicated on serial tag. Place decanter/carafe/airpot under brew basket and turn lower warmer
switch to the "ON" position. Depress brew start switch & check volume of water delivered into decanter/carafe/airpot. Adjust
timer to deliver desired amount of water. Turn timer dial clockwise to increase volume of water, and counter clockwise to
decrease volume.
3.) Allow 10 to 15 minutes for water in tank to heat to brewing temperature. Water has reached brewing temperature when
thermostat clicks off and heating noise stops. Green ready light will be lit on models so equipped. Empty vessels and
replace.
4.) Run one cycle to check for proper temperature setting with an accurate thermometer. Take the temperature of the water at a
point below the brew basket opening, at the start of the brew cycle, and when the vessel is half full. Recommended
temperature is approximately 195°F.
5.) In higher altitudes [5,000 feet above sea level] the thermostat may have to be adjusted to a lower temperature to prevent
boiling.
6.) CAUTION: On faucet models the water faucet will dispense hot water when the handle is depressed. The faucet may be
operated during brew cycle.
NEWCO ENTERPRISES
KB-TCF
KB-3F
Vessels Not Included
Width
Depth
9 1/2"
18"
18"
9 1/2"
16 1/2"
18"
9 1/2"
18"
9 1/2"
18"
INSTALLATION INSTRUCTIONS
KB-2F
Height
Weight
20 1/8"
34
22 3/8"
39
20 1/8"
43
20 1/8"
34
26 1/2"
42
Man. PN: 781224
Rev. 20170309
Watts
Amps
1500
12.5
1600
13.3
1700
14.2
1400
11.7
1400
11.7
| 1
P a g e
Advertisement
Related Manuals for Newco KB-APF
Summary of Contents for Newco KB-APF
- Page 1 Man. PN: 781224 Rev. 20170309 NEWCO ENTERPRISES INSTALLATION, OPERATION, AND SERVICE MANUAL FOR KB SERIES BOTTLED WATER BREWERS KB-APF/LDF KB-TCF KB-3F KB-2F Vessels Not Included Model Warmers Width Depth Height Weight Watts Amps KB-1F 9 1/2"...
- Page 2 COFFEE PREPARATION PROCEDURES • Place filter into brew basket. • Put the proper amount of coffee into the filter. • Slide the brew basket into holder. • On warmer models, place empty decanter on warmer located directly under the brew basket and turn corresponding warmer switch to “ON”...
-
Page 3: Warranty
OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall Newco be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyerʼs customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages. -
Page 4: Troubleshooting Guide
TROUBLE SHOOTING GUIDE SYMPTOM POSSIBLE CAUSE WHAT TO CHECK REMEDY CAN’T START BREW CYCLE No Water Water bottle is empty? Replace empty bottle with No Power Fuse or circuit breaker, new one On/Off Switch power cord & plug Replace or reset circuit Brew Start Switch connections protector as required, unit... - Page 5 TROUBLE SHOOTING GUIDE SYMPTOM POSSIBLE CAUSE WHAT TO CHECK REMEDY WEAK COFFEE Filters Are the correct filters being Insert correct filter Not siphoning properly used? Refer to “DRIPPING” step 1 Improper loading of brew Refer to “Dripping” step 1 Filter centered, coffee bed basket Filter &...
-
Page 6: Wiring Diagram
WIRING DIAGRAM P a g e... - Page 7 NOTES P a g e...
- Page 8 NOTES P a g e...