Direct Tuning; Automatic Tuning - Sony STR-DE675 Operating Instructions Manual

Hi-fi receivers: fm stereo/fm-am receiver
Hide thumbs Also See for STR-DE675:
Table of Contents

Advertisement

Available languages

Available languages

Direct Tuning

For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts” on
page 39.
1
Press TUNER.
The last received station is tuned in.
2
Press FM or AM to select the FM or AM band.
3
Press D.TUNING on the remote.
4
Press the numeric buttons on the remote to enter
the frequency.
Example 1: FM 102.50 MHz
b
b
b
b
1
0
2
5
0
Example 2: AM 1350 kHz
(You don’t have to enter the last “0” when tuning
interval is set to 10 kHz)
b
b
b
1
3
5
0
If you cannot tune in a station and the
entered numbers flash
Make sure you’ve entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5
If you’ve tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive other stations.
z
If you try to enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 9 kHz intervals (to change to 10 kHz intervals, see page 50)
GB

Automatic Tuning

For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts” on
page 39.
1
Press TUNER.
The last received station is tuned in.
2
Press FM or AM to select the FM or AM band.
3
Press TUNING + or TUNING –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING + or TUNING –
again.
Page 40

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents