Creating Your Own Program; Program Play - Sony GX250 Operating Instructions Manual

Creating your own
program

— Program Play

You can make a program of up to 25 steps from
all the discs in the order you want to play them.
You can synchro record the programmed tracks
onto a cassette tape (page 19).
MP3 audio tracks cannot be played on
MHC-GX250, MHC-RG121 and MHC-RG100.
1
Press CD (or FUNCTION repeatedly) to
switch the function to CD.
2
Press PLAY MODE repeatedly in stop
mode until "PGM" appears.
3
Press DISC SKIP (or DISC 1 – 3 or DISC
SKIP/EX-CHANGE on the unit) to select
a disc.
4
Press . or > repeatedly (or turn
l L on the unit) until the desired
track number appears.
When programming the MP3 audio tracks,
press ALBUM – or + to select album, then
press . or > repeatedly (or turn l
L on the unit) until the desired track
number appears.
Disc tray number
5
Press ENTER.
The track is programmed.
The program step number appears,
followed by the total playing time.
14 GB
Selected track number
Total playing time (including
selected track)
6
Program additional tracks.
To program
Other tracks on the
same disc
Other tracks on
other discs
7
Press N.
Program Play starts.
Other operations
To Do this
Cancel Program Press PLAY MODE repeatedly
Play in stop mode until "PGM"
disappears.
Clear a track from Press CLEAR in stop mode.
the end
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press CD
(or FUNCTION repeatedly) to switch the function to
CD, then press N. However, the program is cleared
when you open the disc tray.
• "– –.– –" appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over, or when you select an
MP3 audio track.
Repeat steps
4 and 5
3 to 5