Table of Contents
Advertisement
Security Lock
The projector is equipped with a security
lock function. When you turn the power of
the projector on, you are required to input
the previously set password. If you do not
input the correct password, you will not be
able to project the picture.
Note
You will not be able to use the projector if you
forget your password and the password
administrator is not available. Be please aware
that using the security lock can prevent valid
usage in such cases.
To use the security lock
1
Press the MENU key and then, on the
Function menu, turn on the
setting.
Lock"
2
Enter the password.
Use the MENU, v/V/b/B, and ENTER
keys to enter the four-digit password.
(The default initial password setting is
"ENTER, ENTER, ENTER, ENTER."
After this is entered you can put in your
own password. Therefore, when you use
this function for the first time, please
input "ENTER" four times.)
Next, the screen for entering the new
password is displayed. (Enter the
password on this screen even if you want
to keep the current password.)
16
Security Lock
3
Enter the password again to confirm.
When the following message is
displayed, the setting for security lock is
completed.
"Security
If "Invalid Password!" is displayed on
the menu screen, perform this procedure
again from step 1.
4
Turn the main power off and
disconnect the AC power cord.
The security lock is set to on, then it
becomes effective. The screen used for
Smart APA:
On
Picture
Auto Input Search:
On
Auto Focus:
On
Signal
Test Pattern:
Off
Standby Mode:
Standard
Function
Power Saving:
Off
Installation
Panel Key Lock:
Off
Security Lock:
On
Setup
Information
Sel:
Set:
Back:
Security Lock enabled!
Smart APA:
On
Picture
Auto Input Search:
On
Auto Focus:
On
Signal
Test Pattern:
Off
Standby Mode:
Standard
Function
Power Saving:
Off
Installation
Panel Key Lock:
Off
Security Lock:
Off
Setup
Information
Sel:
Set:
Back:
Invalid Password!
Exit:
Exit:
Hide quick links:
Advertisement
Table of Contents
