How To Put It Together - Bissell 3512-5 Series User Manual

Bissell user's guide cordless upright vacuum cleaner bissell
Table of Contents

Advertisement

This User's Guide has been designed to help you
get the utmost satisfaction from your BISSELL
Upright Vacuum Cleaner. You'll find assembly and
operating instructions, safety precautions, as well as
maintenance and troubleshooting instructions.
Please read this Guide thoroughly before assembling
your vacuum cleaner.

How to put it together

The only tool you'll need to assemble
your vacuum cleaner is a Phillips head
Attach Vacuum Body to Powerfoot
Place Powerfoot on floor with Connector Tube in vertical
1.
position. Place Bag/Body Assembly over Connector Tube
as shown. Stand behind cleaner and push down SLIGHTLY
on top of Bag/ Body Assembly until you hear a click.
Push long bolt through bottom hole on FRONT of Connector
2.
Tube. Place nut over end of bolt and hold in place while
tightening bolt with a phillips head
NOTE: If bolt will not go through hole easily, repeat step 1.
Place Powerfoot and
3.
Bag/Body Assembly
on floor or other
stable surface. Place
Metal Handle into recess on
back of Bag/Body Assembly
as shown.
Align Carrying Handle over screw holes in Bag/Body Assembly.
4.
NOTE: Lower Cord Wrap must point toward BOTTOM of
cleaner.
Install four (4) screws through
5.
Carrying Handle and one (1) screw
through Metal Handle as shown.
Tighten all the screws. Do not
overtighten - product damage
may result.
How to use this guide
®
screwdriver.
screwdriver.
Pay particular attention to the assembly diagram,
assembly instructions, and part names.
Locate and organize all parts before assembly.
Familiarize yourself with the parts and where they go.
Following this User's Guide will greatly enhance your
ability to get the most performance from your
BISSELL
Upright for many years.
®
WARNING:
film can be dangerous. To
avoid danger of suffocation,
keep away from babies and
children.
Attach Hose and
6.
Tools. To attach
Hose with Wand,
open Tool Door
on top cover.
Insert end of Hose
into Hose Port and
fit tabs into notches.
Turn clockwise to
lock. Press Hose into
Hose Clip. Route
Hose over top of
cleaner, through
Hose Hanger on front of
Handle. Place end of Wand
over X-shaped extension and
push down to seat. Snap top
of Wand into Hose Clip.
Attach Tools to caddy in their positions
7.
as shown.
Plastic
4

Advertisement

Table of Contents
loading

Table of Contents