Machine Preparation - Bissell PowerSteamer 1692 User Manual

Machine Preparation

Set up machine following the instructions in The Basics on pages
1.
6-9. Be sure to thoroughly rinse out any remaining Fiber Cleansing
Formula from the Tank-in-Tank bottle to prevent slippery linoleum,
vinyl, and tile floors. Use BISSELL Hard Floor Solutions in the
Tank-in Tank.
Check ReadyTools dial - it should be set on Floor Cleaning.
2.
Plug into a proper outlet and turn Power Switch ON.
3.
Bare Floor Cleaning Technique
Slowly move the machine nozzle with Bare Floor Tool
1.
forward and back over soiled surface one time while
pressing the trigger. Caution: Do not over wet.
Repeat the motion without pressing the trigger using the
2.
Bare Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
3.
Allow about 30 minutes for the floor to dry completely.
4.
When the cleaning job is complete refer to the Maintenance/
5.
Storage section on page 11.
To remove Bare Floor Tool gently bend long tab (right
6.
side) outward and pull tool down away from nozzle.
Rinse thoroughly, dry and store.
How To Clean Upholstery and Small Areas
Important - Check Upholstery Tags
Check manufacturer's tag before cleaning. "W" or "WS" on the tag
means you can use your PowerSteamer If the tag is coded with "X"
or "S" (with a diagonal strike through), or says "Dry Clean Only," do
not proceed. Do not use on velvet or silk. If manufacturer's tag is
missing or not coded, check with your furniture dealer.
Check for colorfastness in an inconspicuous place.
If possible, check upholstery stuffing. Colored stuffing may
bleed through fabric when wet.
Plan activities to give upholstery time to dry.
Vacuum thoroughly to pick up loose debris and pet hair. Use a
vacuum with a brush attachment and a crevice tool to clean in
fabric folds and tufts.
Machine Preparation
Set up the machine following instructions in The Basics sec-
1.
tion, on pages 6-9.
Using the Measuring Cup provided, pour BISSELL Advanced
2.
Deep Cleaning Formula into the Tank-in-Tank.
Set the ReadyTools
3.
10
ug310-5907_1692-1694_205.indd 10 ug310-5907_1692-1694_205.indd 10
™
dial to Tools or PreTreat.
WARNING:
To reduce the risk
of fire, electric
shock or injury
unplug from outlet
before servicing.
Manufacturer's Tag
4/18/05 9:20:04 AM 4/18/05 9:20:04 AM