Setting Up The Channel List; Using Auto Program - Sony KV-27HS420 Instructions: TV stand (primary manual) Operating Instructions Manual

Setting Up the Channel List

Using Auto
Program
z
To exit the Tilt Correction
and Vertical Correction
screens, press the MENU
button.
z
For more details on using
Auto Program, see page 52.
For more details on using Tilt
Correction and Vertical
Correction, see page 59.
32
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
To run Auto Program the first time you turn on your TV
1
Press to turn on the TV.
POWER
The Initial Setup screen appears.
2
Press V v to move the highlight to the desired language, then
press to select that language.
3
The next screen instructs you to connect your cable/antenna.
Check that you've connected your signal source properly.
To start Auto Program, highlight
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen
appears.
4
Press to correct any tilt of the picture. You can choose a
B b
correction between +7 and -7.
When finished, press
5
KV-30/34HS420 Only
v to make a vertical correction to the picture. You can choose a
correction between +5 and -5. When finished, press
When completed, the lowest numbered channel is displayed.
To reset the TV to factory settings
1
Press to turn on the TV.
POWER
2
Hold down on the remote control.
RESET
3
Press on the TV. (The TV will turn itself off, then back
TV POWER
on.)
4
Release .
RESET
and then press
Yes
.
The Vertical Correction screen appears. Press
.
V
.