Rear Panel - Sony KV-27HS420 Instructions: TV stand (primary manual) Operating Instructions Manual

Rear Panel

Jack
1 VHF/UHF
2 S VIDEO IN 1/3
3 VIDEO IN 1/3/4
VIDEO/L(MONO)
-AUDIO-R
4 MONITOR OUT
5 AUDIO OUT (VAR/FIX)
L (MONO)/R
6 CONTROL S
IN/OUT
7 HDMI
(VIDEO 7 IN)
8 HD/DVD IN 5/6
(1080i/720p/480p/480i)
1
2
3
Description
RF input that connects to your VHF/UHF antenna or cable.
Connects to the S VIDEO OUT jack of your VCR or other video equipment that has
S VIDEO. S VIDEO provides better picture quality than either VHF/UHF (1) or
composite video (3) connections.
Connect to the composite A/V output jacks on your VCR or other video
component. A fourth component A/V input jack (VIDEO 2) is located on the front
panel of the TV. This video connection provides better picture quality than the
VHF/UHF (1) connection.
Lets you record the program you are watching to a VCR. When two VCRs are
connected, you can use the TV as a monitor for tape-to-tape editing (not available
with 480p, 720p, or 1080i when the input is set to VIDEO 5-7).
Connects to the left and right audio input jacks of your audio or video equipment.
You can use these outputs to listen to your TV's audio through your stereo system.
Allows the TV to receive (IN) and send (OUT) remote control signals to other Sony
infrared-controlled audio or video equipment that has the CONTROL S function.
HDMI (High-Definition Multimedia Interface) provides an uncompressed, all-
digital audio/video interface between this TV and any HDMI-equipped
audio/video component, such as a set-top box, DVD player, and A/V receiver.
HDMI supports enhanced, or high-definition video, plus multi-channel digital
audio.
Connect to your DVD player's or digital set-top box's component video (Y, P
and audio (L/R) jacks. Component video provides the best picture quality (better
than 1, 2, or 3).
4 5
8
7
6
, P )
B R
11