Sony Bravia KF-42E200A Operating Instructions Manual page 51

Problem
Only snow and noise appear
on the screen
Picture noise (dotted lines or
stripes)
Picture noise when viewing a
TV channel
Stripe noise during playback/
recording of a VCR
Good picture, but noisy sound
Good picture, but no sound
Some tiny black points and/or
bright points on the screen
No color
Lines moving across the TV
screen
No color or irregular color
when viewing a signal from the
Y, P /C , P /C jacks of
B B R R
2
Cause/Remedy
• Check if the antenna is broken or bent.
• Check if the antenna has reached the end of its serviceable life (three to five
years in normal use, one to two years at the seaside).
• Keep the TV away from electrical noise sources such as cars, motorcycles,
or hair-dryers, etc.
• Make sure that the antenna is connected using the antenna cable (not
supplied).
• Keep the antenna cable away from other connecting cables.
• Do not use a 300-ohm twin lead cable as interference may occur.
• Adjust the antenna direction for the minimum interference. Contact a Sony
dealer for advice.
• Select "Manual Program" in the "Program" menu and adjust "Fine" to
obtain better picture reception (page 33).
• Select "Noise Reduction" in the "Picture" menu to reduce the noise in the
picture (page 28).
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the TV to avoid noise.
• Avoid installing your VCR in front of the TV or beside the TV.
• The TV system setting is inappropriate.
If the sound of all the channels are noisy, perform "Auto Program" in the
"Program" menu to preset the channel again (page 33).
If the sound of some channels is noisy, select the channel, then perform
"Manual Program" in the "Program" menu, and select the appropriate TV
system ("TV System") (page 33).
• The volume level is too low. Press 2 + to increase the volume level.
• The sound is muted.
Press %, or 2 + to cancel the muting.
• The broadcast signal has a transmission problem. Press A/B until a better
sound is heard.
• "Speaker" is set to "Off". Set to "On" in the "Sound" menu (page 30).
• "Mono" is selected. Set to "Auto" by pressing A/B (page 19).
• The picture of a display unit is composed of pixels. Tiny black points and/or
bright points (pixels) on the screen do not indicate a malfunction.
• The color intensity setting is too low. Select "Color" in the "Picture" menu
to adjust the color intensity (page 27).
• The color system setting is inappropriate. Select "Color System" in the
"Setup" menu to select a correct color system (page 38). Usually set this to
"Auto".
• The antenna direction needs adjustment. Adjust the antenna direction.
Contact a Sony dealer for advice.
• Select "Reset" in the "Picture" menu to return to the factory settings
(page 26).
• There is interference from external sources, e.g., heavy machineries,
broadcast station nearby. Use the fine tuning ("Fine") function (page 33).
• Check the connection of the Y, P
• Make sure that the Y, P
1, their respective jacks.
/C , P /C jacks of
B B R R
/C , P /C plugs of 1, 2 are firmly seated in
B B R R
1, 2.
Continued
51
GB