Changing Settings - Sony CCU-D50P Operating Instructions Manual

No. Description
CA SDI PLL status
1
2 200 m (656 feet) cable
compensation setting
Return signal mode
3
SKIN-GATE MIX function setting
4
Output mode setting
5

Changing Settings

When the MENU button on the front panel is lit, a
menu appears on the monitor connected to the
MONITOR OUT connector, allowing you to change
the settings of the system including this unit.
To operate the menu
Proceed as follows.
1
Press the MENU button on the front panel, turning
it on.
A menu appears on the monitor connected to the
MONITOR OUT connector.
2
Press the SELECT up or down button to select a
page, and then press the ENTER button.
3
Press the SELECT up or down button to select a
menu item, and then press the ENTER button.
4
Press the SELECT up or down button to select a
setting for the item, and then press the ENTER
button.
Press the CANCEL button to return to the previous
state.
26
Value Page1: Setup Menu page
OK, NG
This page controls camera/camcorder and CCU
ON, OFF
functions.
COLOR, B/W
ON, OFF
Y/C, R/G/B,
Y/B–Y/R–Y
No.
1
2
3
4
5
6
7
8
a) This can also be set for the DXC-D35/D35WS series, but
the setting is ignored.
b) When the CCU command mode (see "qh System setting
switches" on page 18) is set to on (TX7 mode), the
selections for this item are CAM, BARS, and OFF.
When the CCU command mode is set to off (M5A
mode), the selections for this item are ON and OFF. For
details, refer to the operation manual of the camera/
camcorder.
c) Always select 38400 when a RCP-TX7 (not available in
EU countries) is connected. Selecting anything other than
38400 will prevent a connection from being made.
d) This item does not appear when the CCU command mode
is set to off (M5A mode).
*Setup Menu*
1 MATRIX
2 IRIS
3 EVS
4
TITLE
5 CLOCK
6 RCP RATE
7
TLCS
8 SKIN DTL
Function Settings
Switch color matrix STANDARD,
function. a) COLORFUL,
FL LIGHT
Switch AUTO IRIS STANDARD,
mode. SPOT 1.,
BACK 1.
Turn EVS on and off. ON, OFF
Turn TITLE display on ON, OFF
and off.
Turn time display on CAM,
and off. b) BARS, OFF
Set communications 38400, 9600
speed for REMOTE
connector on the rear
c)
panel.
Turn TLCS function on ON, OFF
and off. d)
Turn skin detail ON, OFF
d)
function on and off.
: STANDARD
: STANDARD
: OFF
: OFF
: OFF
: 38400
: OFF
: OFF
Factory
default setting
STANDARD
STANDARD
OFF
OFF
OFF
38400
OFF
OFF