Sony CCU-D50P Operating Instructions Manual page 17

WHITE (white balance automatic adjustment)
button
Adjusts the white balance automatically when the
WHITE/BLACK BALANCE switch is set to AUTO or
PRESET. This button lights when adjustment starts,
and goes off if adjustment is completed successfully. If
adjustment could not be completed successfully, this
button flashes for eight seconds at an intervals of about
0.5 seconds.
ATW (auto tracking white balance) button
Press this button, lighting it, to adjust white balance
automatically according to changes in lighting
conditions.
Black balance adjustment knobs
Adjust the black level.
When the WHITE/BLACK BALANCE switch is set to
MANUAL, the R knob adjust red components and the
B knob adjusts blue components.
White balance adjustment knobs
Adjust the white level.
When the WHITE/BLACK BALANCE switch is set to
MANUAL, the R knob adjust red components and the
B knob adjusts blue components.
q; PHASE adjustment section
SC switch
H (horizontal phase adjustment) screw
Use a screwdriver or other tool to adjust the horizontal
phase difference between the output signal and an
external sync signal.
SC (subcarrier phase adjustment) switch
Adjust the subcarrier phase difference between the
output signal and an external sync signal.
PHASE
H
H screw
SC
I
SC screw
SC (subcarrier phase adjustment) screw
After adjusting the subcarrier phase with the SC
switch, use a screwdriver or other tool to make fine
adjustments by rotating this screw.
qa CABLE COMP (cable compensation)
adjustment section
CABLE COMP
SELECT
CABLE COMP buttons
CABLE COMP (cable compensation) buttons
Use these button to adjust cable compensation for the
length of the cable you are using. The internal cable
compensation circuits prevent signal degradation by
adjusting for the length of the cable. Settings are
displayed in the SHUTTER SPEED/CABLE
LENGTH display window (see page 20).
To change a setting, press the upper or lower button
and keep it pressed for about one second. Then release
the button and press it again within two seconds. Press
and release the button quickly to display the current
setting for two seconds.
Set to "L 25" for a cable 10 m (about 33 feet) or less in
length.
CABLE COMP FINE (cable compensation fine
adjustment) screws
Makes fine compensation adjustments to the video
signal output from the VBS OUT connector. After
using the CABLE COMP buttons to adjust for cable
length, make fine adjustments by rotating these screws
with a screwdriver or other tool. The Y screw adjusts
the Y (luminance) signal, and the C screw adjusts the
C (chroma) signals.
qs DIGITAL TRANSMISSION indicator
Lit in green: Digital signals are being transmitted
from the camera/camcorder by CCZ cable or by
BNC cable connected to the SDI IN connector.
Lit in red: The unit is in digital transmission mode,
but there are no digital video signals being
transmitted from the camera/camcorder.
Flashing in red: The unit is in digital transmission
mode, but there are no digital or analog video
signals being transmitted from the camera/
camcorder because the cables are not connected or
because the camera/camcorder is powered off.
FINE
Y
C
CABLE COMP FINE screws
17