Fluke 700HPPK Instructions Manual

Introduction
The Fluke 700HPP High Pressure Pneumatic Test Pump
(the Product) is a portable device that produces precise
pressures up to 21 MPa (3000 psi). The 700HPPK (the
Kit) includes the Product and a High Pressure Calibration
Manifold (HPM) with hose.
Contact Fluke Calibration
To contact Fluke Calibration, call one of the following
telephone numbers:
•
Technical Support USA: 1-877-355-3225
•
Calibration/Repair USA: 1-877-355-3225
•
Canada: 1-800-36-FLUKE (1-800-363-5853)
•
Europe: +31-40-2675-200
•
Japan: +81-3-6714-3114
•
Singapore: +65-6799-5566
•
China: +86-400-810-3435
•
Brazil: +55-11-3759-7600
•
Anywhere in the world: +1-425-446-6110
To see product information or download manuals and the
latest manual supplements, visit Fluke Calibration's
website at www.flukecal.com.
To register your product, visit
product.
Safety Information
A Warning identifies conditions and procedures that are
dangerous to the user. A Caution identifies conditions and
procedures that can cause damage to the Product or the
equipment under test.
Warning
To prevent personal injury:
•
Read all safety information before you use
the Product.
•
Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
•
Carefully read all instructions.
•
Do not use the Product if it operates
incorrectly.
•
Do not use the Product if it is altered or
damaged.
•
Disable the Product if it is damaged.
•
Do not attempt to operate the Product above
its rated pressure.
PN 4784850
September 2016
© 2016 Fluke Corporation, All rights reserved. Specifications are subject to change without notice. All product names are trademarks of their respective
companies.
High Pressure Pneumatic Test Pump
http://flukecal.com/register-
•
Avoid tipping the Product so that it will fall
over.
•
Use care when working with this Product. Do
not drop the Product or strike it with sharp
objects.
•
Carefully follow the cleaning and
decontamination instructions in the manual.
Do not use unapproved solvents or cleaners
on the product.
Symbols
The symbols shown in Table 1 are found in these
instructions or on the Product.
Table 1. Symbols
Symbol

WARNING.RISK OF DANGER.

Consult user documentation.
Certified by CSA Group to North American safety

standards.

Conforms to European Union directives.
Conforms to relevant Australian Safety and EMC

standards.
This product complies with the WEEE Directive
marking requirements. The affixed label indicates
that you must not discard this electrical/electronic
product in domestic household waste. Product

Category: With reference to the equipment types in
the WEEE Directive Annex I, this product is classed
as category 9 "Monitoring and Control
Instrumentation" product. Do not dispose of this
product as unsorted municipal waste.
700HPPK
Instructions
Definition