Error/Warning Indications; Error Indications; Warning Indications - Sony EXMOR PMW-EX1 Operating Instructions Manual

Error/Warning Indications

The camcorder informs you of situations where
warning, caution, or an operation check is
required, through messages on the LCD monitor/
EVF screen, the tally lamps, and a buzzer.

Error Indications

The camcorder stops operation after the following indications.
Error indication on Buzzer
LCD/EVF
E + Error code Continuous

Warning Indications

When one of the following indications is generated, follow the message to clear the problem.
Warning indication Buzzer
on LCD/EVF
Media Near Full Intermittent
Media Full Continuous
Battery Near End Intermittent
Battery End Continuous
Temperature High Intermittent
Voltage Low Intermittent
Insufficient Voltage Continuous
Battery Error
Please Change Battery.
Backup Battery End
Please Change.
The buzzer is output to the built-in speaker or to
the headphones connected via the headphone
connector. The buzzer volume can be adjusted
with "Alarm Level" in "Audio Output" of the
AUDIO SET menu.
Tally Cause and measures
lamps
Rapidly The camcorder may be defective.
flashing Turn off the power and consult Sony service personnel.
(If power cannot be turned off by setting the power switch to
OFF, remove both the battery pack and the DC IN source.)
Tally Cause and measures
lamps
Flashing Free space on the SxS memory card has become insufficient.
Replace it with another at the earliest opportunity.
Rapidly No space is left on the SxS memory card. Recording, clip
flashing copying and clip division cannot be performed.
Replace it with another.
Flashing The battery power will be exhausted soon.
Charge the battery pack at the earliest opportunity.
Rapidly The battery pack is exhausted. Recording cannot be
flashing performed.
Connect a power source via the DC IN connector or stop
operation to charge the battery pack.
Flashing The internal temperature has risen above a safe operation
limit.
Suspend operation, turn off the power, and wait until the
temperature falls.
Flashing The DC IN voltage has become low (stage 1).
Check the power supply.
Rapidly The DC IN voltage is too low (stage 2). Recording cannot be
flashing performed.
Connect other power source.
An error was detected with the battery pack.
Replace the battery pack with a normal one.
The remaining power of the backup battery is insufficient.
Replace the battery with a new one.
Error/Warning Indications 123