Int Mic Set; Int Mic Sens; Int Mic Wind - Sony HVR-Z1N Operating Instructions Manual

INT MIC SET

INT MIC SENS

INT MIC WIND

XLR SET
XLR CH SEL
XLR AGC LINK
66
Using the Menu
You can set the wind noise reduction and the sensitivity for the external
microphone.
GNORMAL
The standard setting.
HIGH Use this setting to record a quiet sound. When a loud sound is recorded
with this setting, the sound may be distorted. Make a trial recording in
advance.
GOFF Select when you want to record the sound as it is without reducing the
noise caused by wind.
AUTO Select to reduce the noise caused by wind.
You can select the input signal from an external microphone, and the channel to
be recorded.
GCH1
Select to record the input signal from the INPUT1 connector to
channel 1, and that from the INPUT2 connector to channel 2.
CH1, CH2 Select to record the input signal from the INPUT1 connector to
channels 1 and 2.
You can select whether the AGC (Auto Gain Control) of channel 1 is linked with
or separated from channel 2 when using an external microphone.
GSEPARATE Select to record the sound in channel 1 separately from that in channel
2 (AGC separated).
LINKED Select to record the sound in channel 1 and that in channel 2 as a set,
like stereo sound (AGC linked).
Note
b
• The [LINKED] setting is valid only when the AUDIO SELECT switches of both channels
are set to AUTO, and the same item is selected for [INPUT1 LEVEL] and [INPUT2
LEVEL].
appears on the status check display.