Recording On A Device Connected Via An I.link Cable - External Rec Control - Sony HVR-Z1N Operating Instructions Manual

Press the ASSIGN button assigned to the
index function.
When pressed during recording
appears for about 7 seconds and an index
signal is recorded.
When pressed in the standby mode
flashes.
After you press REC START/STOP to start
recording, appears for about 7 seconds and
an index signal is recorded.
To cancel the operation
Before starting to record, press the ASSIGN
button assigned to the index function again.
b Note
• You cannot record an index signal on a recorded tape
afterward.
Recording on a device
connected via an
i.LINK cable –
External REC Control
By connecting the camcorder to an HDV/
DVCAM/DV compatible device (digital HD
video camera recorder, digital video camera
recorder, hard disc recorder, etc.) with an
i.LINK cable, recording can be performed on
this camcorder and on the connected device
simultaneously, or relayed from the
camcorder to the connected device when the
tape in the camcorder comes nearly to the
end.
Refer also to the instruction manuals supplied
with the devices to be connected.
1
Connect the camcorder and the device
using an i.LINK cable (p. 89).
2
Set the POWER switch to CAMERA.
3
Press MENU.
,continued
45
Recording