Sony Handycam DCR-DVD610 Operating Manual page 22

Step 2: Charging the battery pack (Continued)
To remove the battery pack
1 Turn the POWER switch to OFF
(CHG).
2 Slide the BATT (battery) release lever
(1) and remove the battery pack (2).
BATT (battery)
release lever
b Notes
• When you remove the battery pack or the AC
Adaptor, make sure that the
(Still) lamp (p. 25)/ACCESS lamp (p. 30)/
access lamp (p. 32) are turned off.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (p. 119).
To use a power source from a wall
outlet (wall socket)
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
22
(Movie) lamp/
Remaining battery (approx.)
Recording capacity (approx.)
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Battery pack
NP-FH40
(supplied)
NP-FH50
NP-FH70
NP-FH100
Recording time
Approximate time (min.) available when
you use a fully charged battery pack.
When recording on the internal
memory (DCR-DVD810) or a
"Memory Stick PRO Duo"
DCR-DVD610
Battery pack
NP-FH40
(supplied)
NP-FH50
NP-FH70
NP-FH100
Charging time
125
135
170
390
Continuous Typical
recording recording
time time*
110 50
120 55
130 60
140 65
280 130
300 140
625 300
680 325