Sony Handycam Vision CCD-TRV14E Operating Instructions Manual page 71

Sony operating instruction video camera recorder ccd-trv14e/trv24e
Hide thumbs Also See for Handycam Vision CCD-TRV14E:
Table of Contents

Advertisement

Trouble check
AC power adaptor
Symptom
The POWER lamp does not
light.
The CHARGE lamp flashes.
When the CHARGE lamp flashes
Check through the following chart.
Remove the battery pack from the
AC power adaptor. Then install the
same battery pack again.
$
When the CHARGE lamp flashes
again
Install another battery pack.
$
When the CHARGE lamp flashes
again
The problem is with the AC power
adaptor.
$
Please contact your nearest Sony
dealer in connection with the
product with the problem.
If you use a battery pack which you have just bought or which has been left unused for a long
time, the CHARGE lamp may flash at the first charging. This does not indicate a problem.
Repeat again to charge with the same battery pack.
Cause and/or Corrective Actions
• Set the selector to VTR (DC OUT) and disconnect the mains
lead. After about one minute, try again. (p. 9)
• See the following chart.
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, there is no
problem.*
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, the problem is
with the battery pack installed first.
CCD-TRV14E/TRV24E 3-859-266-12(1).E/R
$
$
71

Advertisement

Table of Contents
loading

This manual is also suitable for:

Handycam vision ccd-trv24e

Table of Contents