Bernina Happy Voyager Resource Manual page 73

Bernina happy voyager resource manual
Table of Contents

Advertisement

Happy Voyager
Basic Machine Maintenance-Cleaning and Lubricating
29
Weekly Cleaning
Every 40 hours of operation clean the area below
the needle plate, including the thread cutter.
1. With the machine turned off and disconnected
from the mains remove the needle plate using the
offset screwdriver.
2. In the back of the machine remove the rubber
cap. With the blue handled 3mm hexagonal T-
driver and turn the main shaft clockwise to the
"C" point, (275 degrees)
3. From the left hand side insert the manual lever
and pull down and hold it in place. The turn the
main shaft clockwise to the "L" point, ( 0 de-
grees) to open the thread cutter.
4. Clean out any waste thread and dust from the
thread cutter knife and surrounding area.

Advertisement

Table of Contents
loading

Table of Contents