Advertisement
Quick Links
Installation Instructions
PR-12, PR-12BE and PR-20BE Active Antenna Power Supplies
All power supplies are strapped for either 110 or 220 VAC at the factory.
The strapping can be changed by a qualified technician in the field, as shown on the
diagram at the bottom of this page.
The AC input block accepts either 110 or 220VAC (depending on strapping).
Pin 1 AC Hot (connect one AC lead here)
Pin 2: Not used.
Pin 3: Neutral AC (connect other AC lead here).
Pin 4: Ground or Cable Shield
The DC input block accepts either 12 VDC or 24 VDC.
Pin 1: +12VDC
Pin 2: +24VDC
Pin 3 Negative
Naval Electronics, Inc.
7028 West Waters Ave Suite 393, Tampa, Florida USA 33634
Phone (813) 885-6091, Fax (813) 885-3601, E-mail sales@naval.com
Advertisement
Summary of Contents for Naval Electronics AB PR-12
-
Page 1: Installation Instructions
Installation Instructions PR-12, PR-12BE and PR-20BE Active Antenna Power Supplies All power supplies are strapped for either 110 or 220 VAC at the factory. The strapping can be changed by a qualified technician in the field, as shown on the diagram at the bottom of this page. - Page 2 PR-12BE Component Layout Diagram Naval Electronics, Inc 7028 W Waters AVE, #393, Tampa, FL 33634 Phone :+ 1-813-885-6091, email : sales@naval.com PR-12BE Antenna DC Fuse 150MA Output1 Red LED AC Fuse Over Current Indicator Signal 150MA Attenuator Green LED Power Indicator Output2 Transformer 220v...