Table of Contents
Advertisement
B
14
ASIC
The GlassMaster LT controller is designed with the beginning fuser in mind. It is important to have a good
general understanding of the principals of glass before programming your kiln. Therefore we recommend reading the
General Firing Guidelines section of this manual before programming the kiln.
S
1 - S
IDLE S
TEP
TART IN
To start programming the kiln must be in an IdLE state. This can be verifi ed by the display alternating between the cur-
rent temperature and the message IdLE. When the kiln is fi rst plugged in it will read "PF" indicating that there was a power
rent temperature and the message IdLE. When the kiln is fi rst plugged in it will read "PF" indicating that there was a power
interruption. To return to IDLE Mode Press
Press
once you are in IDLE Mode to begin the programming process.
S
2 - S
F
TEP
ELECT
IRING
To Display Current Firing Mode Press
The display will read either "AUTO" or "PRO". If the display reads "AUTO" it is currently set in the GlassFire
Mode.
Press
to select this mode..
If the display reads "PRO" it is currently set in the Ramp and Hold Mode. Press
Press
to select this mode.
S
2 - S
S
TEP
ELECT
PEED
The controller will display the current firing
speed. The display will read SLo, MEd, or
FASt for slow, medium, or fast heating rates.
Use the chart to the right to help select the
appropriate speed for the size of your project.
Press
or
to scroll to the desired firing
speed.
Press
to select the displayed heating rate.
S
3- S
P
TEP
ELECT
ROCESS
Next the controller will display the current
process. The display will read SLP, tAC, or
FULL for slump, tac-fuse, or full-fuse pro-
cesses.
Press
or
to scroll to the desired
Process.
Press
to select the displayed Process.
F
S
IRING
TEPS
TATE
M
ODE
2 - A
M
UTO
ODE
1/8" Thick - 18" diameter or smaller
F
1/4" Thick - 4" diameter or smaller
AST
3/8" Thick - Not recommended
1/8" Thick - 20" diameter or smaller
M
1/4" Thick - 8" diameter or smaller
EDIUM
3/8" Thick - 5" diameter or smaller
1/8" Thick - 24" diameter or smaller
1/4" Thick - 18" diameter or smaller
S
LOW
3/8" Thick - 12" diameter or smaller
1/2" Thick - 8" diameter or smaller
For a metric conversion of this chart visit
our website at http://www.skutt.com/glass/
products/hotstart.php
(G
F
)
LASS
IRE
or
to scroll to "AUTO".
Hide quick links:
Advertisement
Table of Contents
