Setting Internet Service Provider Connection; Type To Static Ip - Belkin Wireless G Plus MIMO Router F5D9230-4 User Manual

Alternate Setup Method
Setting your Internet Service Provider (ISP) Connection

Type to Static IP

A static IP address connection type is less common than other connection
types. If your ISP uses static IP addressing, you will need your IP address,
subnet mask, and ISP gateway address. This information is available from
your ISP or on the paperwork that your ISP left with you. Type in your
information, then click "Apply Changes". After you apply the changes,
the Internet Status indicator will read "connection OK" if your Router is set
up properly.
1. IP Address
Provided by your ISP. Enter your IP address here.
2. Subnet Mask
Provided by your ISP. Enter your subnet mask here.
3. ISP Gateway Address
Provided by your ISP. Enter the ISP gateway address here.
4. My ISP Provides More Than One Static IP Address
If your ISP assigns you more than one static IP address, your
Router is capable of handling up to five static WAN IP addresses.
Select "My ISP provides more than one static IP address" and enter
your additional addresses.
(1)
(2)
(3)
(4)
37
1
2
3
4
5
6
7
8
9
10