Setting Up Parental Control; Automatic Setup - Belkin Network Router User Manual

Automatic Setup

The Router must be connected to the Internet before setting up Parental Control.
If you have not set up the Router to connect to the Internet, follow the steps in
your Quick Installation Guide to set up the Router before attempting to set up
Parental Control.
Automatic setup is the easiest way to get Parental Control up and running.
After setting up the Router to connect to the Internet for the first time, a setup
page will automatically be displayed when you open your browser. Follow the
steps below.
1. Open a browser on any computer on the network. A page will be displayed
prompting you to sign up for Parental Control for six months FREE. If this
page does not display, follow the instructions for Manual Setup in the next
section of this guide.
2. Select the option that lets you enable Parental Control. If you delay the
decision to sign up by clicking "Later", the Router will prompt every six hours
until a decision is made. If you click "Never", you will not be reminded again.
You can manually enable Parental Control at any time later by following the
Manual Setup instructions.
3. You will be prompted to ceate a password and provide an e-mail address to
which change notifications should be sent. Enter the e-mail address you wish
to use, and enter a password to be used to manage the Parental Control
function. Note: This password is different than the password used to manage
the Router and should be unique to keep unauthorized users from changing
the Parental Control settings.
4. Once you have entered this information, the Parental Control feature is
activated. To view or change the settings, follow the directions in the section
called "Managing Parental Control Settings."

SETTING UP PARENTAL CONTROL

3