ACR Electronics Nauticast Y1-03-0212 Installation Manual page 93

Acr electronics automatic identification system installation manual
Table of Contents

Advertisement

Quick Replacement Guide
Inland AIS
1. Prepare the following tools:
Screwdrivers, spanners,
User Password: [your personal password]
(Should be written to you user manual - Appendix 7.3.
The factory default password is on the display foil)
2. Read out your Transponder configuration:
This form guides you to save the most important
settings (bold marked) prior to an AIS replacement.
Voyage related settings may be stored here as well, but
we assume you know how to key them in.
Steps to do this:
Press Menu
2.AIS Status
Press 2
2.Own Ship Data
Press 2
Write down your current configuration settings:
IMO No. :
ShipName :
ShipType :
Length :
Cargo :
Draught :
(Press Enter
to reach 2.screen view for)
ENI:
Blue Sign:
Convoy:
Load:
Persons on Board:
Crew:
Int'l:
Reference Points:
Press Menu
4.Ship Settings
Press 4
[UserPassword]
Type in
Write down the current configuration settings here:
RefPtExt:
A
RefPtInt:
A
Blue Sign:
Press
Menu
5.Transponder Configuration
Press
5
[UserPassword]
Type in
7.Inland AIS Configuration
Press
7.
Speed:
<LOW*> or <High*>
Course :
<LOW*> or <High*>
Heading:
<LOW*> or <High*>
Blue Sign:
[not avaliable] or [Used]
*(most time LOW)
Sensor Settings:
When you have connected a external GPS or Compass
to your AIS:
Press Menu
5.Transponder Configuration
Press
5
[UserPassword]
Type in
5.Sensor Settings
Press 5
[ServicePassword] Press Enter
Type in
MMSI:
ATIS:
Cargo:
Beam :
Hazard:
Support:
Passengers:
Press Enter
B
C
D
B
C
D
Press Enter
Press Enter
Write down the current configuration
settings here:
BaudRate Sensor1:
BaudRate Sensor2:
BaudRate Sensor3:
Press M8 Back
3. Detach the device
3.1. Bracket Mounting
3.2. Frame Mounting
4. Disconnect cables
4.1. AIS-Cable to unscrew
4.2. VHF/GPS Cable to unscrew
5. Unpack the new Transponder
New factory default password is on its display
protection foil
6. Connect cables
6.1. AIS-Cable to screw on
6.2. VHF/GPS Cable to screw on
7. Mount the replacement unit
7.1. Bracket Mounting
7.2. Frame Mounting
8. Type in the configuration settings from
above:
Following steps to type in the Configuration
MMSI/IMO – Number:
The AIS will prompt 'ENTER MMSI NUMBER'
Press M5 OK
MMSI and IMO number
Type in
Press
M5 Save (AIS will Restart)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nauticast inland - installation rev eNauticast 2662

Table of Contents