Entering The Mmsi / Imo / Dac / Esn Numbers - ACR Electronics Nauticast Y1-03-0212 Installation Manual

Acr electronics automatic identification system installation manual
Table of Contents

Advertisement

4.2 Entering the MMSI / IMO / DAC / ESN Numbers

Select from the Main Menu "Service Configuration" Number 6. This option requires the
SERVICE password. The default password from the factory is mentioned on your AIS display
at the protection foil. Please see the appendix in your User Manual for additional password
information. Enter Service Password and use the up and down arrows on keypad to select
"Change MMSI / IMO" than press M5 "Select" or "by pressing number 3 on the keypad.
Input your MMSI and IMO number and press Save to store data. Unit will reboot itself after
pressing Save. Continue to 4.2 after reboot.
Service Configuration Menu Example:
Note: MMSI and IMO Data input are limited to 9 characters.
Installation Manual
o
o
N 1
19' E
0
13' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| Menu
-----| |
| +- 1. Messages
View | +- 2. AIS Status
| +- 3. Voyage Settings
-----| +- 4. Ship Settings
| +- 5. Transponder Configuration
Msg. | +- 6. Service Configuration
| +- 7. Display Settings
-----| +- 8. Graphical Display Settings
|
Displ|
----------------------------------------
NUM|Select->|
o
o
N 1
21' E
0
14' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| 6. Service Configuration
-----| |
| +- 1. Change Service Password
View | +- 2. User Password Settings
| +- 3. Change MMSI / IMO
-----| +- 4. Change DAC / ESN
| +- 5. Change AIS Mode
Msg. | +- 6. Restore Factory Settings
|
-----|
|
Displ|
----------------------------------------
NUM| Select->|
|
|<-Back
|
|<-Back
33
Y1-03-0212 Rev. E

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nauticast inland - installation rev eNauticast 2662

Table of Contents