Timer Setup; Sleep Timer; Event Timer - Silvercrest KH 2157 Operating Manual

Timer Setup

The URC offers 2 timer modes, sleep timer and event timer.

Sleep timer

1. Press the device button e for the device that is to be con-
trolled (i.e. VCR).
2. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
3. Press the  or  button t until "TIMER SETUP" is
shown. Press the OK button k "TIMER SLEEP" appears in
the LCD display q. Confirm the selection of this function
with the OK button k.
4. Now, below to the right in the LCD display q blinks the
minutes for the remaining time of the selected device.
Set with the  or  button t the desired value from 1
to 99 minutes. Press the OK button k to confirm.
5. Position the remote control in such a way that your infra-
red signal can reach the device to be switched off. After
expiration of the set time the remote control will switch the
device off.
6. To check if the SLEEP timer is activated press the S button
r. Then below to the left in the LCD display q "SL" will
be shown.

Event timer

The remote control has 4 event timers available via which
you are allowed to send out specific series of button combi-
nations at designated times.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "TIMER SETUP" and
confirm with the OK button k. "TIMER SLEEP" appears
in the LCD display q. With the  or  button t select
the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button k.
3. Now the hour of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired hour and press for con-
firmation the OK button k.
4. Now the minutes of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired minutes and press for
confirmation the OK button k.
5. In the LCD display q you will see "TIMER X KEY" (X
stands for the desired timer). Now press the desired
device button e followed by the desired sequence of the
button commands.
6. Press the S button r to save your entry and to return to
the timer menu.
7. Procede in a similar manner in order to, if required,
programme the other timer memory slots also.
- 16 -