Data Sets - Siemens MICROMASTER 440 Operating Instructions Manual

Issue 10/06
6.4.19

Data sets

For many applications it is beneficial to have the possibility to change several
parameter settings simultaneous during operation or in the state ready to run with
an external signal. By indexing it is possible to set a parameter to several values
which can be activated by data set change-over. There are the following data sets:
CDS Command Data Set
DDS Drive Data Set
Command data set (CDS)
P0810 =...
Command data set CDS bit 0 (local / remote)
Selects the command source in which bit 0 should be read-out to select a command data
set (CDS).
Selecting CDS
BI: CDS bit 1
P0811
BI: CDS b0 loc/rem
P0810
Active CDS
r0050
The currently active command data set (CDS) is displayed using parameter r0050.
P0811 =...
BI: CDS bit 1
Selects command source from which to read Bit 1 for selecting a command data set
(see P0810).
Example for CDS changeover:
CDS1: Command source via terminals and setpoint source via analog input (ADC)
CDS2: Command source via BOP and setpoint source via MOP
CDS changeover is realized using digital input 4 (DIN 4)
Steps:
1. Carry-out commissioning for CDS1 (P0700[0] = 2 and P1000[0] = 2)
2. Connect P0810 (P0811 if required) to the CDS changeover source
(P0704[0] = 99, P0810 = 722.3)
3. Copy from CDS1 to CDS2 (P0809[0] = 0, P0809[1] = 1, P0809[2] = 2)
4. Adapt CDS2 parameters (P0700[1] = 1 and P1000[1] = 1)
DIN4
Terminals
BOP
ADC
MOP
MICROMASTER 440
Operating Instructions (Compact)
3
(0:0)
2
1
(0:0)
0
Changeover time
3
2
1
0
P0810 = 722.3
P0700[0] = 2
0
1
P0700[1] = 1
P1000[0] = 2
0
1
P1000[1] = 1
Changeover time
approx. 4 ms approx. 4 ms
Sequence control
Setpoint Motor
channel control
6 Commissioning
0
CO/BO: Act CtrlWd2
r0055 .15
r0055
.15
CO/BO: Act CtrlWd1
r0054 .15
r0054
.15
t
CO: Active CDS
r0050
t
69