Starting a Flooded Engine
1. Disconnect the spark plug lead,
then use the spark plug wrench to
remove the spark plug (turn
counter-clockwise to remove).
2. If the spark plug is fouled or is
soaked with fuel, clean or replace
the plug as required. For correct
spark plug size and gapping
procedure, see page 26.
3. Clear excess fuel from the combus-
tion chamber by cranking the
engine several times while the
spark plug is removed.
4. Replace the spark plug and tighten
it firmly with the spark plug
wrench. If a torque wrench is
available, torque the spark plug to
140–165 inch-pounds (170–190
kgf
cm).
●
CAUTION!
Incorrect spark plug installation
can result in serious engine
damage!
5. Repeat the starting procedure for a
warm engine.
6. If the engine still fails to fire or
start, refer to the troubleshooting
chart at the end of this manual.
Stopping
Turn the switch "OFF'' after idling at
low speed for 1 to 2 minutes.
18
35719
Cutting with the Saw
THINK SAFETY!
Clear a safe work area
before cutting.
Wear close-fitting
clothing to protect your
legs and arms. Do not
wear clothing or jewelry
that could get caught in
machinery or brush.
35716
Keep a proper footing—do
not overreach!
Wear appropriate
non-skid footwear.
IMPORTANT!
Use full throttle while cutting! Forcing
the saw into the work reduces cutting
performance and also increases
operator fatigue!
Stop the saw before moving it
from the work area.
Always wear hearing
protection (ear plugs or ear
muffs) to protect your
hearing
Always wear eye
protection such as a face
shield or goggles.
Use full-throttle while
cutting, and apply
only enough bar
Always wear gloves
pressure to maintain
when operating the
engine speeds of
saw.
7000-8000 rpm.
Never operate with a loose
cutting chain!
Never operate the saw if
fastenings are loose or
missing!
Never operate the saw if any
component parts are dam-
aged, loose, or missing!
23