Image Projection; Turning The Projector On - Sharp Notevision PG-B10S Operation Manual

Image Projection

Turning the Projector on

Connect the required external equipment to the
projector before carrying out the following pro-
cedures. (See page 50.)
Info
The language preset at the factory is English.
If you want to change the on-screen display to
another language, reset the language accord-
ing to the procedure on page 48.
1
Plug the power cord into the wall
outlet.
The power indicator illuminates red, and
the projector enters standby mode.
2
Press on the projector or
on the remote control.
The power indicator illuminates green.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
The lamp indicator illuminates, indicating
the status of the lamp.
Green: The lamp is ready.
Blinking in green: The lamp is warming up.
Red: The lamp should be replaced.
If the projector is put into the standby
mode and immediately turned on
again, the lamp indicator may take
some time to illuminate.
When "Anti-Theft" is set, the keycode
input box will appear. Enter the keycode.
For details about the Anti-Theft function,
refer to "Anti-Theft (Setting the Anti-
Theft)" on page 46.
When bringing the image into focus or
adjusting the projection image size, see
page 22.
When adjusting the projection angle,
see "Using the Adjustment Feet" on
page 23 or "Variable Lens Shift Feature"
on page 24.
-18
Power indicator
Lamp
indicator
MKeycode input box
ON button
ON button