Ej Report Reading And Resetting - Sharp XE-A201 Instruction Manual

A201_4 FOR THE MANAGER

EJ REPORT READING AND RESETTING

The cash register provides electronic journal (EJ) function. This function is intended to record the journal data in
a memory instead of journal paper, and print the data as an EJ report. The register records the journal data in
REG, PGM, , X1/Z2 and Z2/Z2 modes. By default, a maximum of 2000 lines are stored in the memory.
For details of EJ programming, please refer to "Electronic Journal (EJ) Programming" section (page 40).
Printing journal data on the way of a transaction
You can print journal data of a current transaction recorded in EJ memory by pressing the
transaction.
This function is valid when the printing style is set to receipt type on the programming, and also the
receipt ON/OFF function is set to OFF.
• Sample print
Reading and resetting the electronic journal data (Issuing EJ report)
You can read the journal data stored in the EJ memory in the journal format by executing the following
procedure in the X1/Z1 or OP X/Z mode.
To read all of the data:
7: @
To reset all of the data:
7: P
To read the last 10 records:
710
• To stop reading or resetting the data, turn the mode switch to
"MGR" position. The data will not be erased when resetting.
• On the EJ memory, a maximum of 2000 (or 1000, depending
on programming) lines of data can be stored. When executing
all data reading, all of the data stored in the EJ memory will be
printed.
60
01.11.11 10:23 AM Page 60
EJ report title
EJ report end title
A
@ A
@ A
R
• Sample EJ report
key during the
Header
information
print