Troubleshooting Guide - Shark V1510 Owner's Manual

TROUBLE SHOOTING GUIDE
PROBLEM POSSIBLE REASON
1. Power cord not firmly plugged
HAND VACUUM into outlet.
WILL NOT 2. No power in wall outlet.
OPERATE 3. Needs servicing.
4. Thermostat has tripped.
HAND VACUUM 1. Dust cup is full.
WILL NOT PICK-UP 2. Unit clogged.
OR SUCTION 3. HEPA Dust Cup Filter needs
POWER IS WEAK cleaning or replacing.
1. Dust cup is full.
DUST ESCAPING 2. HEPA Dust Cup Filter is not
FROM HAND installed correctly.
VACUUM 3. There is a puncture/hole in
HEPA Dust Cup Filter.
HAND VACUUM
HOSE OR 1. Hose clogged.
BRUSHES WILL 2. Dust cup is full.
NOT PICK-UP
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset breaker.
3. Call 1 (800) 798-7398.
4. Turn the unit off and unplug
from outlet.
1. Allow unit to cool down,
then Restart. Empty dust
cup – (see page 5).
2. Turn unit off and unplug
from wall outlet. Remove
HEPA Dust Cup Filter and
check for object(s) in air
duct and remove.
3. Clean or replace HEPA
Dust Cup Filter.
(see page 5)
1. Empty dust cup.
2. Review HEPA Dust Cup
Filter instructions.
(see page 5)
3. Replace HEPA dust cup
filter. (see page 5)
1. Remove hose and/or
brushes. Remove
obstruction from hose.
2. Empty and clean dust cup.
7
ORDERING REPLACEMENT DUST CUP FILTERS
FOR REPLACEMENT FILTER INFORMATION
for Model V1510
Call:
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
Or visit our website:
www.sharkvac.com
Item
Replacement HEPA Filter
For Technical Support
for Model V1510
Call:
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
Please Note:
The HEPA Dust Cup Filter is washable. It should, however, be replaced
every six (6) months to ensure peak performance of your vacuum.
Important:
Make sure that HEPA filter is completely dry before re-installing back in the
hand vacuum.
1 (800) 798-7398
Part #
XF1510
1 (800) 798-7398
8