To Install Shifter Lever Knob; To Check/Adjust Clutch Control Cables - Craftsman 536.886531 Owner's Manual

............... ASSEMBLY .............
TO INSTALL SHIFTER LEVER KNOB
• Thread the shifter lever knob onto the threaded end
ol the shilter lever until it is snug against the hex nut
and the lip is pointed toward the engine Tighten the
hex nut against the botlom o! the shift lever knob (See
Fig 6)
TO CHECKJADJUST CLUTCH
CONTROL CABLES
The control cables, Fig. 7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
belore you use your snow thrower
For instructions on checking or adjusting the control
cables, see ToAdjust Clutch Control Cables paragraph on
page 18
SHIFTER KNOB
""_"_'\ __H E X N U T
HEX
_._. LEVER
F,GI'6 "'
TRACTION CLUTCH LEVER AUGER CLUTCH LEVER
OFF __ FF
I I, ft- _ ]] ]
, .......... ON
CONTROL CABLES
FIG.7