Download Print this page
Sears 139.53859 Owner's Manual

Sears 139.53859 Owner's Manual

3-function remote control

Advertisement

Quick Links

Owner's
Manual
Model
139.53879
3-Function
Remote
Control
To comply
with FCC rules, adjustment
or moditicalions
o! 1his receiver
end!or
transmitter
are prohibited
except for changing
the code seltlng or replacing
the
battery
THERE ARE NO OTHER USER SERVICEABLE
PARTS
The 53000 Series remote control works only with
door openers
and light controls
having a green
"SRT" button and green indicator
light.
Instructions
are given below for programming
your
opener to match the remote control's
code. The
additional
remote control
buttons
can also activate
other garage door openers
and/or light controls.
(Instructions
for programming
light products
are
included
with those accessories.)
Program
the Opener to Accept
the Remote Control Code
Select a remote control push button to operate the
receiver The large button is recommended for use with
the garage door opener.
1 Press and HOLD the selected remote control push
button, Figure 1_
2. Then press and release the green "SRT" button on the
right side panel of the opener in Figure 2oThe opener
light wit flash once.
3 Retease the remote control push button
Now the opener wilt operate when the remote control
push button is pressed
If you release the remote control push button before
the opener light flashes,
the opener has not
accepted
the code.
To Change the Selected Push Button
On the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you need to
erase aflthe learned codes and reprogram each remote
control used to operate the garage door opener
To Erase All Remote Control Codes
. Press and hold the green "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds). All the codes the opener has learned will
be erased.
- To reprogram, repeat Steps I - 3 for each remote
control in use,
Code programming
instructions
are also located on
the opener
panel.
Replacement
Parts:
]
3_Function remote control housing only (no circuit board) - 4 IA4873;
Compact
remote control housing only (no circuit board) - 4 IA4874;
3V 2016 Lithium Battery - 10A!9 (2 required); Visor Clip - 29£I 34
L
Model
139.53859
Compact
3-Function
Remote
Control
operating
or playing
with a garage door
opener
can injure
themselves
or others.
The
garage door could close and cause serious
Injury
or death.
Do not allow
children
to operate
the
door push button(s)
or remote control(s).
A moving
garage
door
could
Injure
or kill
someone
under It. Activate
the opener only when
you
can
see
the
door
clearly,
it is free
of
obstructions,
and Is properly
adjusted.
......
I_L
i,
i,I
'
in
FIGURE 1
select
e remote control push
button 1ooperate opener
3-Function
Remote Control
Compact 3-Function
Remote Control
53000 Series Garage Door Openers
(With Green "SRT" Button and Green Indicator
Light)
Green "SRT"
Button
Green Indicator
Ught
The Remote Control
Batteries
The lithium batteries should
j._-,,,..3-FUNCTtON
produce power for up to 5 years.._,,'_-._res_
'toh'_ve;dd
Replace batteries positive side
_-,_,-_.._:z_
cracking
.own, as , oliows
3-Function remote.: Use the C-_L_
Twlst _&')
visor clip or screwdriver
_,_
",--_., toop_r,
COMPACT
blade to pry open the case
as shown To repIace the cover, insert the 3 tabs at the
opposite end and snap shut
Compact remote Use a screwdriver b!ade to pry open
the case as shown To replace cover, snap shut along
both sides
© 1995, Sears Roebuck & Company
114A 1959
All Rights Reserved
Pnnled in Mexico

Advertisement

loading

This manual is also suitable for:

139.53879