Installing Motor Pulley - Sears Craftsman 113.21371 Owner's Manual

9. Gently push down on the FEED HANDLES until the
head raises upwards as far as it will go.
10, TIGHTEN THE HEAD LOCK HANDLE AND THE
QUILL LOCK HANDLE.
11. HOLD onto the Feed Handle and UNLOCK the quill
lock handle.
12, Let the quill return to the UP position in the head.
!3. TIGHTEN THE QUILL LOCK HANDLE.
Repeat steps 3 thru 10 until the head is raised to the
desired position, Position HEAD SUPPORT COLLAR
underneath the head and tighten the bolts.
HEAD LOCK
HANDLE
HANDLE
CAUTION: Do not raise the head above the top of the
column.
INSTALLING MOTOR PULLEY
When using a double shaft motor, remove the KEY from
the 5/8 in, dia. shaft.
1.
Using a 5/32 in, setscrew wrench, UNSCREW the
setscrew in the pulley so that it is clear of the
KEYWAY (GROOVE).
2. Place the pulley on the shaft. Make sure it slips on
EASILY ,.. don't FORCE it, Remove any burrs in the
pulley or on the shaft if any,
3. Position the pulley so that the KEYWAYS in the shaft
and in the pulley line up; and the small end of the
pulley is about !/16 of an inch away from the motor.