Page 1
6/2 AMP MANUAL BATTERY CHARGER Model No. 200.71206 CAUTION: Read and Follow All Safety Rules and Operating Instructions Before Every Use of this Product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 0000000508-1196 OWNER’S MANUAL...
If, within two years from the date of purchase this battery charger fails due to a defect in materials or workmanship, simply RETURN IT TO THE NEAREST SEARS STORE IN THE UNITED STATES, and Sears will repair or replace it, free of charge.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of explosion, explosive gases, or injury while using your battery charger, follow the precautions listed below: • Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery.
BEFORE USING YOUR BATTERY CHARGER It is important to prepare your charger for use. This section will tell you about your charger's electrical requirements and how to prepare a battery for charging. PLUGGING IT IN WARNING: Electrical Shock Hazard Be sure that power cord fits properly into outlet.
USING YOUR BATTERY CHARGER For best results from your battery charger, learn to use it properly. This section tells how to set the controls and how to charge a battery in or out of the vehicle.
AMMETER pointer will fall to about half the charge rate selected. For specific positions, refer to the “Ammeter” section in “Using your battery charger” on page 6. 10. When the battery is fully charged, unplug the charger power cord before attempting to disconnect charger clamps.
Page 8
10. Stand away from the battery and remove thecharger leads from the NEGATIVE connection first, then from the POSITIVE battery post or terminal. 11. Clean and store the battery charger in a dry location.
CALCULATING CHARGE TIME The Chart Method Use the following table to more accu- rately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart. • Small batteries — motorcycles, garden tractors, etc.
Page 10
Calculating Charge Time (Continued) When you know the percent of charge and the AmpHour (AH) rating of your battery, you can calculate the approx- imate time needed to bring your battery to a full charge. To convert Reserve Capacity to Amp Hour (AH) Rating, divide Reserve Capacity by 2, and add 16: AH = Reserve Capacity + 16...
MAINTENANCE AND CARE A minimal amount of care can keep your battery charger working properly for years. Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion.
Use shorter or heavier extension cord. Sulfated battery will eventually take a normal charge if left connected. If the battery will not take a charge, have it tested by a qualified Sears technician. Continue charging battery. Continue charging. Buzz is not abnormal.
This section shows an illustration of your battery charger. Use it to become familiar with where all the parts are located, and what they look like. Replacement Parts List Sears 71206 Description Item Cover Heatsink/Diode Assembly Base AC Power Cord...
Page 16
For the repair or replacement parts you need Call 7 am - 7 pm, 7 days a week 1-800-366-PART (1-800-366-7278) For the location of a Sears Repair Service Center in your area Call 24 hours a day, 7 days a week 1-800-488-1222...