FTK-127i130 Buitt-in Trim Kit lnstaHtation instructions
For use with the following
microwave
oven ACM2160A
and UMC5200AA
Proper installation
is the instailer's
responsibility!
Write the model & sedal numbers on the owner's manual,
The model number label is }ocated on the oven front=
UL Listed-For
use over electric
heat source
models
(Wail Ovens)
27": ACES2730, AOCS2740,
MEW5527DD, MEW6527DD
30": ACES3030, AOCS3040,
MEW5530DD, MEW6530DD,
AEW3530DD, AEW4530DD,
JJW8130DD, JJW9130DD
WARNING
I
To avoid risk of electrical shock, personal injury, or
death, disconnect power to wall outlet before beginning
installation.
Parts, Tools,
and Materials
The following
parts are supptied
with the oven:
Trim Frame (1)
Side Duct (1)
u
o IS
Bottom Duct (1)
Template (1)
Upper Duct (1)
1" Screws
(4 required, 2 extra)
1/2" Screws
(11 required, 2 extra)
Bottom Bracket (1)
Anti-Tip Bracket (1)
Too_s required
to perform
installation:
Phillips Screwdriver
Saw (Electric or Hand)
Drill with 1/16"and %4" drill bits (Electric or Hand)
Tape Measure
Pencil
Framing Square
Level
Shipping
Weight
Approximate shipping weight is 16 Ibs=
Cutout
Dimensions
Dimensions
Heiqht
Width
Depth (min.)
27"
16 3/4"
25 1/2"
23 3/4"
30"
16 3/4"
25 1/2"
23 3/4"
ht
Electric Heat Source Model
I
A
WARNING
To avoid risk of electrical shock, personal injury, or
death:
, Before drilling into the wall, note where electrical
outlets are and where electrical wire might be
concealed behind the wal!, YOU COULD GET AN
ELECTRICAL
SHOCK if you contact electrical wire
with the drill bit.
o Locate and disconnect the power to any electrical
circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT
THE POWER, YOU
COULD GET AN ELECTRICAL
SHOCK.
i
AlL
CAUTION
]
To avoid personal injury, wear gloves when handling the
metal parts. Parts are sharp and can cause cuts and
abrasions.