Battery Charger Controls - Schumacher SE-1275A Owner's Manual

Schumacher owner's manual battery charger se-520ma, se-5212a, se-1275a
Hide thumbs Also See for SE-1275A:
Table of Contents

Advertisement

Available languages

Available languages

F.
OPERATION - Model SE-1275-A
Two switches permit Battery Type and Charge Rate selection.
Switch #1 permits selection of either Conventional or
Maintenance Free and Deep Cycle batteries. If you are not sure
of your battery type, use the (Regular) Conventional Setting.
Switch #2 (3 Charge Rate Modes)
Mode 1 -- Select 2 amp automatic for 12 volt smaller (<31 AH
(Ampere Hour)) or warm larger lead-acid batteries.
Mode 2 -- Select 12 amp automatic for larger 12 volt batteries
for a fast charge.
Mode 3 -- Select 75 amp Engine Start to assist in engine cranking
of 12 volt systems. DO NOT use on 6 volt systems. Use the 75
amp engine start position for cranking automobiles or light trucks.
Use only with battery in the vehicle. This will reduce the chance
of damaging sensitive electronic equipment in the vehicle.
BATTERY TYPE
(SWITCH #1)
REGULAR
DEEP CYCLE
BATTERIES
BATTERIES
OPERATION -- Model SE-5212-A
Two switches permit Battery Type and Charge Rates selection
Switch #1 permits selection of either Conventional or
Maintenance Free and Deep Cycle batteries. If you are not sure
of your battery type, use the (Regular) Conventional Setting.
Switch #2 (3 Charge Rate Modes)
Mode 1 -- Select 2 amp automatic for 12 volt smaller (<31 AH
(Ampere Hour)) or warm larger lead-acid batteries.
Mode 2 -- Select 10 amp automatic for larger 12 volt batteries
for a fast charge.
Mode 3 -- Select 50 amp Engine Start to assist in engine cranking
of 12 volt systems. DO NOT use on 6 volt systems. Use the 50
amp engine start position for cranking automobiles or light trucks.
Use only with battery in the vehicle. This will reduce the chance
of damaging sensitive electronic equipment in the vehicle.
BATTERY TYPE
(SWITCH #1)
CONVENTIONAL
MAINTENANCE
AND LOW
FREE AND
MAINTENANCE
DEEP CYCLE
BATTERIES
BATTERIES
OPERATION -- SE-520-MA
This charger has two switches.
Switch #1
Mode 1--Manual Position: Use for charging in 2 amp or 10 amp
Charge Rates on 12 volt batteries only. This charging must be
monitored and stop charging when the battery is charged.
Overcharging will damage the battery.

BATTERY CHARGER CONTROLS

CHARGE RATE
(SWITCH #2)
2 AMP
12 AMP
75 AMP
ENGINE START
CHARGE RATE
(SWITCH #2)
50 AMP
10 AMP
2 AMP
EN-
G I N E
START
AUTOMATIC FOR
MANUAL
MAINTENANCE
FREE AND
DEEP CYCLE
(SWITCH #1)
BATTERIES
AUTOMATIC FOR CONVENTIONAL
LOW MAINTENANCE BATTERIES
Mode #2--Automatic Position for Conventional Batteries. If you
are not sure of your battery type, use the (Regular) Conventional
Setting.
Mode 3--Automatic Position for Maintenance Free and Deep
Cycle batteries.
Switch #2 (2 Charge Rate Modes)
Select either 2 amp Charge Rate for small batteries or 10 amp
Charge Rate for larger batteries.
NOTE: A buzz, or hum is normal when the output cables have
been disconnected and the AC power cord is still connected to
an electrical source (i.e. wall outlet).
3
CHARGE RATE
(SWITCH #2)
2 AMP
10 AMP

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se-520maSe-5212a

Table of Contents