Fully automatic microprocessor controlled battery charger with engine starter plus battery tester and alternator tester for 12-volt batteries (16 pages)
Fully automatic microprocessor controlled battery charger with engine starter plus battery tester and alternator tester for 6 and 12-volt batteries (32 pages)
Fully automatic microprocessor controlled battery charger with engine starter plus battery tester and alternator tester for 12-volt batteries (32 pages)
Fully automatic microprocessor controlled battery charger with engine starter plus battery tester and alternator tester for 12-volt batteries (32 pages)
Fully automatic microprocessor controlled battery charger with battery tester for 12-volt batteries (32 pages)
Summary of Contents for Schumacher SpeedCharge 7000A
Page 1
OWNER’S MANUAL Model 7000A For 12-Volt Batteries Fully Automatic Microprocessor Controlled Battery Charger with Engine Starter plus Battery Tester and Alternator Tester CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Schumacher Electric Corporation Mount Prospect, IL 60056 U.S.A.
LIMITED WARRANTY ... 16 PLEASE SAVE THIS OWNER’S MANUAL AND READ BEFORE EACH USE. The Model 7000A, Fully Automatic Battery Charger/Tester and Engine Starter, offers features to accommodate the needs for home or light commercial use. This manual will explain how to use this battery charger safely and effectively. Please read and follow these instructions and precautions carefully.
Wash hands after handling. • Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery. • Use charger only on lead-acid type rechargeable batteries, such as those used in cars, trucks, tractors, air- planes, vans, RV’s, trolling motors,...
• Always operate the battery charger in an open, well-ventilated area. • Never smoke or allow a spark or flame in the vicinity of the battery or engine.
BEFORE USING YOUR BATTERY CHARGER It is important to understand the charger’s requirements. This section explains the charger’s electrical requirements and how to prepare a battery for charging. PLUGGING IT IN Your charger requires a 120V AC receptacle installed according to all local codes and ordinances.
OPERATING INSTRUCTIONS IMPORTANT: Follow all safety instructions and precautions when charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well-ventilated area. CHARGING BATTERY IN THE VEHICLE: 1. Avoid personal injury by keeping clear of fan blades, belts, pulleys and other engine parts.
GROUNDED USING ENGINE START POWER OUTLET Your battery charger can be used to jump start your car if the battery is low. Follow these instructions on how to use the ENGINE START feature. IMPORTANT: Follow all safety instruc- tions and precautions when charging your battery.
CHARGER CONTROL Charge Rate LEDs Display Mode LEDs Switch Buttons 7000A CONTROL PANEL BATTERY TYPE SWITCH Use this switch button to set the type of battery to be charged to one of the following three. • REGULAR: This is the type of battery usually used in cars, trucks, and motorcycles.
Battery Council International scale. TESTING SEQUENCE There are four basic steps required to use the 7000A as a battery tester. 1. Connect the charger battery clamps to the battery. Be sure to follow all of the precautions listed under “OPERATING INSTRUCTIONS”.
TESTING SEQUENCE There are three basic steps required to use the 7000A as an alternator tester. 1. Connect the charger battery clamps to the battery or charging system. Be sure to follow all of the precautions listed under “OPERATING INSTRUC-...
The buttons are ignored. The digital USING YOUR BATTERY CHARGER OVERVIEW Using this battery charger is very simple. First, connect the battery and AC power following the precautions listed under “OPERATING INSTRUC- TIONS”. Then select the appropriate BATTERY TYPE and CHARGE RATE for your battery.
COMPLETION OF CHARGING: Charge completion is indicated by the CHARGED (green) LED; when lit, the charger has stopped charging and switched to the Maintain Mode of operation. MAINTAIN MODE: When the CHARGED (green) LED is lit, the charger has started Maintain Mode. This mode of operation is also known as Float-Mode Monitoring.
Such batteries should not be charged using the 20A rate. The 20A rate is for charging larger batteries. The 7000A charges at the selected charge rate and eventually reduces the charge rate in a controlled man- ner. After the charging process has...
MAINTENANCE AND CARE A minimal amount of care can keep your battery charger working properly for years. 1. Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion.
MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE. Schumacher Electric Corporation warrants this battery charger for five years from date of purchase at retail against defective material or workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer.