Inserting Media - SATO GL408e / GL412e Quick Start Manual

7.2 Inserting media

Fig. 7 Inserting media, printer
Fig. 8 Inserting media, sensor cover
2. Now, pull the power cable from the power outlet.
3. Remove the power cable out of the hook and pull the power
cable from the printer.
1. Open the media cover.
2. Install the media roll (1) on the roll paper feeder (3). Adjust the
roll guide (2), so that the media roll can rotate.
3. Open the print head assembly (8) by using the print head
latch (4).
4. Thread the media under the media damper (5) and the media
sensor cover (11), between the platen roller (7) and the print
head assembly (8).
Align the inside edge of the media (9) with the inside media
edge guide (10), so that they touch each other.
5. Loosen the media width guide (6) by turning the knob counter
clockwise. Adjust the guide lightly against the outside edge of
the media (12). Tighten the guide by turning the knob
clockwise.
6. Close the print head assembly.
7. Close the media cover.
14
GL408e / GL412e Barcode Thermal Printer
Setup and initial operation