Manual Fine Tuning; Adding And Erasing Channels - Sanyo AVL-209 Instruction Manual

Manual Fine Tuning

1
Repeat steps 1~3 in [Selecting the Signal Source] to access Channel page.
2
Press CH+/- repeatedly to select Fine Tune item.
3
Press VOL+/- to fine tune till the best possible picture and sound are
obtained.
If you fine tune a program manually, the AFC will be turned off automatically.

Adding and Erasing Channels

1
Use number buttons to directly select a channel that will be added or erased.
2
Repeat steps 1~3 in [Selecting the Signal Source] to access Channel page.
3
Press CH+/- repeatedly to select Channel Skip item.
4
Press ENTER or VOL+/- to select On or Off.
When the item is set to on, the selected channel will be erased.
When the item is set to off, the selected channel will be added.
The erased channels can not be selected by using the CH+/- buttons unless you use number buttons to
input channel number directly.
Memorizing the Channels
(continued)
Channel
Auto Searching
Source Cable
Channel Skip On Off
Fine Tune
AFC
On Off
Frequency 55.25 MHz
Move Select Menu to exit
Channel
Auto Searching
Source Cable
Channel Skip
On Off
Fine Tune
AFC
On Off
Frequency 55.25 MHz
Move Select
Menu to exit
16