Simplicity TV CO-AXIAL SOCKET User Manual

TV CO-AXIAL / SATELLITE / RJ45 DATA
/ TELEPHONE (MASTER / SLAVE) SOCKET

SAFETY WARNING

Before use please read carefully and use in accordance with these safety instructions.
This product must be installed by a competent person in accordance with the current
editions of the IEE Wiring Regulations (BS7671) and Buildings Regulations. If in any
doubt, consult a qualified electrician.
These products must not be installed in the same enclosure as equipment rated in excess
of 50V, (e.g. mains rated 13A sockets or switches). Read the instructions carefully before
starting the installation process and keep them safe for future reference.
IF IN ANY DOUBT, PLEASE CONTACT A QUALIFIED ELECTRICIAN.
WARNING
Do not exceed the load rating as shown on the back of the product
Retrotouch (UK) Ltd, Suite 1 Kelvin House, Kelvin Way, Crawley, West Sussex, RH10 9SE.
U.K. Tel: + 44 (0) 1293 279426 Fax: +44 (0) 1293 471444 email: info@retrotouch.co.uk
FRONT COVER REMOVAL
Flat aperture recess
To remove trim cover to access fixing holes, insert a flat headed screw driver into the
aperture on the under side of the switch (as shown) and twist to remove.
INSTALLATION
Important: Please read the information on the previous safety page before
commencing any work.
1. Remove the fixing screws (2) from the bag supplied.
2. Undo the terminal screws until they no longer obstruct the cable entry holes.
3. Trim wires to correct length allow cable to reach terminals comfortably.
4. Connect the wires to the correct terminals according to the marking on the
back of the product and wiring diagram.
5. When replacing a switch, take note of the wire positions and terminal markings
on the old switch.
6. Carefully push the wired unit back into the mounting box, ensuring the cables
are not trapped or pinched.
7. Fit and tighten the fixing screws as supplied. Do not over tighten the screws as
it may cause damage to the front plate or the mounting box threads.
Technical queries should be made to Retrotouch Technical Sales and Service Department
Tel: +44 (0) 1293 279426 email: support@retrotouch.co.uk
1
TV CO-AXIAL SOCKET
Step 1. Strip back the rubber sleeve 15mm and inner white plastic core
to 5-8mm, this should leave 7-10mm of conductor length. (as shown)
Step 2. Fold back the braiding over the rubber sleeve (as shown)
Step 3. Insert the cable into the clamp and tighten screws (as shown)
Step 4. Insert conductor into metal fixing plate and tighten screw
15mm
5-8mm
2
Fixing plate
Cable Clamp