Power Cord Specifications - Bay Networks BayStack 303 User Manual

Using the BayStack 303 and 304 Ethernet Switches
Table 1-3. Front-panel LEDs (continued)
Type Label
100 Mb/s speed 100
indicator
*
Half/full-duplex * F Dx
* Indicator applies to 10/100BASE-TX port only (port 13 on BayStack 304 and port 25 on BayStack 303).
The unit AC power supply status LED and the system status LED work together
to provide status information.
Table 1-4.
Power
Off
On
On
On
Power Cord Specifications
For installation outside North America, make sure you have the proper power cord
for your region. Any cord used must have a CEE-22 standard V female connector
on one end and must meet the IEC 320-030 specifications.
Caution: Use only power cords with a grounding path. Without a proper
ground, a person touching the unit is in danger of receiving an electrical shock.
Lack of a grounding path to the unit may result in excessive conducted or
radiated emissions.
1-8
Color State
Green On
Off
Green On
Off
Table 1-4
Power and Status LEDs
Status Meaning
Off System off.
Off System fault detected by power-up diagnostics.
Blinking System is powered on and performing self-tests or network
configuration.
On Normal operation.
Meaning
Port is operating at 100 Mb/s.
Port is operating at 10 Mb/s.
10/100 Mb/s port is operating in full-duplex mode
(simultaneous transmit and receive).
10/100 Mb/s port is operating in half-duplex mode
(transmit or receive).
provides the meaning of the two LEDs.
893-01010-A