EasyPro EPL20 Instructions For Operation

EPL20 • EPLK1 • EPLK2 • RL20
Thank you for purchasing the EasyPro submersible pond
light. With this pond light you can make your fountain glow,
illuminate your pond from within, highlight your waterfall
and extend the enjoyment of your water feature in the eve-
ning hours. This light is full submersible and carries a three
year limited warranty. You can also change the bulb to a
different wattage if you need more illumination, by simply
changing the bulb. Replacement bulbs are available. The
EPL20 lights can be purchased individually or as a kit with
one or two lights and a transformer.
Safety and Electrical Connections:
Always disconnect the electrical supply before
1.
handling, maintaining, repairing or installing any
pond equipment.
2. Light(s) must be attached to a 12 volt UL listed trans-
former.
3. Never hook the lights directly to a 110 volt or higher
outlet.
4. Connect the transformer only to a 110 volt receptacle that is protected by a Ground
Fault Circuit Interrupter.
5. Do not use this product in bathrooms or swimming pools.
6. All electrical work must be performed by a qualified technician. Always follow the National
Electrical Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial
codes. Code questions should be directed to your local electrical inspector. Failure to follow
electrical codes and OSHA safety standards may result in personal injury or equipment dam-
age. Failure to follow manufacturer's installation instructions may result in electrical shock, fire
hazard, personal injury or death, damaged equipment, provide unsatisfactory performance and
may void manufacturer's warranty.
20 Watt, 12 Volt, Submersible
Underwater Lights
Instructions for Operation • Safety • Warranty
1