Potterton Gold HE A Range Installation & Service Instructions Manual page 18

Terminal Position with Minimum Distance (Fig. 18)
A a Directly below an opening, air brick, opening
windows, etc.
B a Above an opening, air brick, opening window etc.
C a Horizontally to an opening, air brick, opening window etc.
D Below gutters, soil pipes or drain pipes.
E Below eaves.
F Below balconies or car port roof.
G From a vertical drain pipe or soil pipe.
H From an internal or external corner.
I Above ground, roof or balcony level.
J From a surface or boundary line facing a terminal.
K From a terminal facing a terminal (Horizontal flue).
From a terminal facing a terminal (Vertical flue).
L From an opening in carport (e.g. door, window)
into the dwelling.
M Vertically from a terminal on the same wall.
N Horizontally from a terminal on the same wall.
R From adjacent wall to flue (vertical only).
S From an adjacent opening window (vertical only).
T Adjacent to windows or openings on pitched and flat roofs
U Below windows or openings on pitched roofs
a In addition, the terminal should be no nearer than 150 mm to an
opening in the building fabric formed for the purpose of accommodating
a built-in element such as a window frame. See BS 5440 Pt. 1.
NOTE: The distance from a fanned draught appliance terminal
installed parallel to a boundary may not be less than 300mm in
accordance with the diagram below
Terminal
Assembly
Top View Rear Flue
Fig. 17
R
I
F
L
18
© Baxi Heating UK Ltd 2008
300 min
*
Property Boundary Line
T
J,K
N
M
I
G
Likely flue positions requiring
a flue terminal guard
(mm)
300
300
300
25
25
25
25
25
300
1. The following guidelines indicate the general requirements
600
for siting balanced flue terminals. For GB recommendations
1200
are given in BS 5440 Pt 1. For IE recommendations are given
600
in the current edition of I.S. 813 "Domestic Gas
1200
Installations".
1500
300
2. If the terminal discharges onto a pathway or passageway,
300
check that combustion products will not cause a nuisance
1000
and that the terminal will not obstruct the passageway.
600
2000
3. If a terminal is less than 2 metres above a balcony, above
ground or above a flat roof to which people have access,
then a suitable terminal guard must be provided.
Plume
Displacement Kit
Air Inlet
U
D
A
C
E
I
S
B
J,K
F
A
A
H
H
I
Fig. 18
7.0 Site Requirements
7.8 Flue
NOTE: Due to the nature of the boiler a plume of water
vapour will be discharged from the flue. This should be
taken into account when siting the flue terminal.
IMPORTANT:
• Only ONE 25mm clearance is allowed per installation.
• Under car ports we recommend the use of the plume
displacement kit.
• The terminal position must ensure the safe and
nuisance - free dispersal of combustion products.
IMPORTANT: If fitting a Plume
Displacement Flue Kit, the air inlet
must be a minimum of 100mm from
any opening windows or doors (see
Section 9.0).
Opening Window
or Door
100mm
Fig. 18a
MIN.
I